A few days ago I went to buy some stuff at a DIY store nearby, and I noticed a pack of blank wooden cubes with rounded corners. First, I idly considered that they would make great d6s if only they had some kind of marking on them. Then, I considered how easy it would be to mark them with a woodburning tool. Well, to make a long story short:
- 20201112_125733.jpg (22.94 KiB) Viewed 7542 times
...I just HAD to make these custom greco-persian wars Triumph! dice (a blank cube is also shown). In case you wonder, the persian die is marked with old cuneiform numerals, and the greek die is marked with attic numerals. I think both are period-appropriate, but I'm happy to discuss any mistake! Cuneiform was a bit tricky until I discovered that you just have to indent the surface with a straight tool while keeping it tilted at 45°angle- all those tiny triangles will just appear automatically, which makes sense. Experimental archaeology at work!
One word of caution: despite being called a
woodburning tool, I've found that it quite readily burns flesh, too- as the large blister on the middle sausage, pardon finger, in the photo above can attest. No pain, no gain, I presume. Can't wait to roll lots of PI for the greeks
